NEXON PS8 User Manual Page 30
- Page / 82
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Page 30/82 PS SERIES HARDWARE SETUP PROCEDURE
• The PS Series Rigging System requires regular inspection and testing by a competent test
centre. NEXO recommend that the system is load tested and certified annually or more
frequently if local regulations require.
• When de-rigging the system ensure that the same duty of care is given to the procedure as for
the installation. Pack PS Series components carefully to prevent damage in transit.
7.1.1 Ground Stacking Safety
Statistically, many more injuries occur due to unstable ground stacked PA systems than those
associated with flown systems. There are several reasons for this fact, however the message is clear:
• Always survey the supporting structure upon which a ground stack is to be built. Always look
beneath PA wings to inspect the deck support and if necessary ask for the stage scrims and
dressings be removed to allow access.
• If the stage surface slopes, as it does in some theatres, ensure that the system is prevented from
sliding forwards due to vibration. This may require the fitting of timber battens to the stage floor.
• For outdoor systems ensure that that the system is protected from wind forces which might
cause the ground stack to become unstable. Wind forces can be huge, especially upon large
systems, and should never be underestimated. Observe meteorological forecasts, calculate the
“worst case” effect upon the system prior to erection and ensure that the system is secured
appropriately.
• Take care when stacking cabinets. Always employ safe lifting procedures and never attempt to
build stacks without sufficient personnel and equipment.
• Never allow anyone, whether operators, artists or members of the public to climb onto a ground
stacked PA system. Anyone who needs to climb over 2m (6 ft) high should be fitted with suitable
safely equipment including a clip-on harness. Please refer to local Health and Safety legislation in
your territory. Your dealer can help with advice on access to this information.
• Apply the same attention to all safety matters when de-stacking systems.
• Be aware that safety procedures are as important in the truck and in the warehouse as they are
at the venue.
7.1.2 Contacts
Correct training is fundamental to safe practise when working with loudspeakers flying systems. NEXO
recommend that users contact local industry associations for information on specialist course.
Information for International training agencies can be obtained by contacting either:
The Production Services Association
(PSA),
School Passage,
Kingston-upon-Thames,
KT1 SDU Surrey,
ENGLAND
Telephone: +44 (0) 181 392 0180
Rigstar Training and Testing Center
82 Industrial Dr. Unit 4
Northampton, Massachusetts 01060 U.S.A.
Phone: 413-585-9869 -- Fax: 413-585-9872
school@rigstar.com
ESTA
Entertainment Services & Technology Association
875 Sixth Avenue, Suite 1005
NEW YORK, NY 10001 USA
Phone: 212-244-1505 – Fax: 212-244-1502
- www.esta.org
- PS Series 1
- BASIC PRECAUTIONS 2
- INTRODUCTION Page 3/82 3
- HIGH SOUND PRESSURE LEVELS 4
- CONTENTS 5
- NTRODUCTION 6
- INTRODUCTION Page 7/82 7
- 1 INTRODUCTION 8
- GeoD Passive mode 9
- Crossover 80Hz 9
- 2.1 Speaker connection 10
- 3.1.1 Current rating 12
- 3.1.2 Amplifier settings 12
- Gain value 12
- Operating Mode 13
- IMPORTANT 16
- ONNECTION DIAGRAMS 17
- Speakon 4 20
- BRIDGED MODE 21
- 6.1 Principle 27
- 6.2 Change of configuration 27
- 7.1 SAFETY FIRST 29
- 7.1.2 Contacts 30
- 7.2 General Description 31
- Procedure 37
- 7.4.1 Touring Accessories 39
- R > H 40
- ANALOGUE PSTD CONTROLLERS 46
- RISK OF ELECTRIC SHOCK 47
- DO NOT OPEN 47
- 8.4.1 Read before use 50
- 8.4.2 Front Panel 50
- Output Level Switch 52
- Audio Outputs 52
- Sense inputs 52
- Earth Lift 52
- Sub jumper 52
- Displacement control 54
- Temperature control 54
- Dynamic control 54
- Peak Limiter 54
- 9 TECHNICAL SPECIFICATIONS 55
- 9.1 PS8 – LS400 55
- 9.1.2 Dimensions 56
- 9.1.3 Diagrams 57
- 9.2 PS10R2 – LS600 58
- 9.2.2 Dimensions 59
- 9.2.3 Diagrams 60
- 9.3 PS15R2 61
- 9.3.2 Dimensions 62
- 9.3.3 Diagrams 63
- 9.4.1 Specifications 64
- Dimensions 65
- ECHNICAL SPECIFICATIONS 70
- 9.8 Accessories List 80
- Page 82/82 USER NOTES 82
© 2020, manymanuals.com. All rights reserved. | 0.695 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals